Maytag Washer Door Lock Problems

Should have no issues solving these maytag washer problems.

Maytag washer door lock problems.

If the washer will not unlock at the end of a wash cycle unplug the washer or disconnect power. Washer lid lock problems. This washer has sensors that detect the water supply and requires both hoses to have water going to the water valve. Inspect the door lock for damage.

The door lock secures the washer door shut during operation. If the door lock is defective the washer door will not latch properly. If it does not detect both water supply hoses are turned on the control detects a problem with the water pressure sensor. Door refuses to lock.

If the washer starts and seems to progress through the cycle well but doesn t move to the spin cycle the problem may be with the locking lid switch. This might be caused by a programming function so might be best to consult a local maytag repairman. Were you using a fresh hold cycle available on some models. If the door lock switch does not engage fully the washer will not move into the high spin mode.

When using one of these cycles the door will remain locked until the cancel button is pushed. The door lock can fail either mechanically or electrically. This is not a problem for top load washers as this applies to the front load models. Door locked at the end of the cycle.

This washer sensor problem usually will show up in the form of a fault code like f7e1 f7e5 or f7e7. The lid lock is a default feature of your maytag front loading and top loading washer to prevent opening the appliance while the cleaning cycle is in progress. Washer actuator and tub sensor problems. This is a guide about unlocking the door on a maytag front load washer.

And the washer will not start or run properly. Front loaders have a locking mechanism to avoid opening the door during a washing cycle but occasionally this lock will be activated accidentally. The lid latch has been a sore spot on this washer type. Most often washer lid latch problems result in the washer not starting or.

Pausing the wash cycle is how it can be disabled.