Washer lid lock problems.
Maytag washer not sensing.
Model mvw7232h based on 18 lb load 5 0 5 4 cu.
The lid latch has been a sore spot on this washer type.
Set the water level knob to the auto sensing setting and the washer will fill to a level that ensures the load engages the agitator.
This washer has sensors that detect the water supply and requires both hoses to have water going to the water valve.
Please make sure both inlet hoses are connected and both hot and cold water supplies are turned on.
Washer actuator and tub sensor problems.
Models mvw6230h mvw6230rh based on 16 lb load 4 5 4 9 cu.
Your washer may go through a series of small fills to get to the appropriate water level.
I have lightened the load switched the type of laundry being washed and ran water through the fabric softener place since there was fabric softener that had not drained still in it.
These sensing spins may take 2 to 3 minutes before more water is added to the load.
From this point the electronic control will sense the load and determine if additional water is needed.
It is perfectly normal for the machine to hum or buzz when it fills with water or is in the process of sensing the load size.
If your washing machine is functioning properly until your washing machine has been able to wash to the rinsing stage then suddenly dies then it is possible that your washing machine is stuck and this can cause your washing machine to get caught.
If the water level seems too low or if the washer does not fill completely auto sensing helps stabilize the amount of water used.
And the washer will not start or run properly.
Next the washer will use short slow spins to estimate the load size.
The washer senses the size of the load and adds the correct amount of water for the load size.
You may notice during a cycle that the wash load is not completely submerged in water.
Opening the lid will put the washer into a pause and you will have to press the start button to continue the cycle.
Models with extra power option.
Most often washer lid latch problems result in the washer not starting or.
Why would my 4 month old maytag washer keep sensing for an hour and never start.
Whirlpool duet washer stuck on sensing.
This washer sensor problem usually will show up in the form of a fault code like f7e1 f7e5 or f7e7.
If it does not recognize both water supply hoses are turned on the control detects a problem with the water pressure sensor.
It also makes gurgling noises when the machine drains wash or rinse water.
The washer will then move the load briefly pause to allow water to soak.
