If the washer will not unlock at the end of a wash cycle unplug the washer or disconnect power.
Maytag washing machine door locked blinking.
The lid lock flashing reasons causes and repair solutions are for most whirlpool kitchenaid maytag amana and kenmore top loading washing machines.
It s possible the drain hose extends more than 4 5 114 mm into the standpipe.
Maytag front load washer door will not open.
The door lock led light will blink.
The washer will go into a hold and drain routine for 8 minutes.
If not i recommend calling a service technician to diagnose and repair the washer.
Is water hooked up to the washer and turned on.
When attempting this make sure power is off to the washer and use extreme caution.
You could have a failed control console or a bad electronic control board in the washer.
Does the drain pump run constantly.
The door should unlock after 60 seconds.
Fresh hold option is on.
The washer door will unlock at the end of the drain.
This is a guide about unlocking the door on a maytag front load washer.
While this option is on the fan blows and the load is tumbled periodically for up to 12 hours.
Front loaders have a locking mechanism to avoid opening the door during a washing cycle but occasionally this lock will be activated accidentally.
Wait approximately 2 minutes for control to reset.
I have a control lock on my front load washer.
Answered by a verified appliance technician we use cookies to give you the best possible experience on our website.
Is the door locked and the add a garment light on.
My maytag front load washer has a blinking door locked and the door will not open up.
Water remaining in washer after cycle.
During this period you will be able to hear the pump running.
The door may immediately unlock.
Select drain spin to remove any water remaining in the washer.
1 year old it s a 4 3 cu ft.
After 8 minutes the door will unlock.
Is the door locked and the add a garment light off.
Did you just install.
If the control locked light will not turn off i recommend unplugging the washer for 5 minutes.
Nothing else will appear to be happening with the machine during this time.
The door remains locked during this time.
Reconnect power to washer plug in.
Looking at your use and care guide page 31 trouble shooting i have held read more.
When using one of these cycles the door will remain locked until the cancel button is pushed.
Plug the unit back in and see if the controls will respond.
Run a drain and spin cycle.
It is flashing red door locked.
The control lock on bottom right is solid red.
